Connect locally
Use the router's Wi-Fi or an Ethernet cable. Guest networks may block the admin page.
Access your router's admin panel at 192.168.8.1 to change your Wi-Fi password, update network settings, or fix login errors for Huawei and mobile broadband routers.
Follow these checks before changing Wi-Fi or security settings.
Use the router's Wi-Fi or an Ethernet cable. Guest networks may block the admin page.
Open http://192.168.8.1 in the browser address bar.
The router login can be different from the Wi-Fi password printed on the label.
Save one setting at a time and keep a note of the original value.
Most failures come from the wrong network, a mistyped address, browser search, VPN routing, or a router that uses another gateway.
Open the guide that matches the gateway shown by your phone, laptop, or computer.
192.168.8.1 is a private IP address used as the default admin gateway primarily by Huawei (4G/5G mobile hotspots, CPE routers) and GL.iNet travel routers. It is not a public website. You can only open this page when your smartphone, tablet, or computer is directly connected to the router's local Wi-Fi or Ethernet network.
Inside the router's web-based management page, you can monitor mobile data usage, read SMS messages received by your SIM card, change your Wi-Fi name (SSID) and password, and update the device firmware.
To secure your mobile broadband network, log in to the 192.168.8.1 dashboard. Navigate to Wi-Fi Settings or WLAN Basic Settings. Enter your new password in the "Wi-Fi Password" or "WPA Pre-Shared Key" field, then click Save. Your router will restart its wireless signal, and you will need to reconnect your devices using the new password.
For most Huawei routers, the default username and password is admin / admin. If you are using a portable mobile hotspot (MiFi), remove the back cover and take out the battery; the default IP, Wi-Fi password, and admin password are usually printed on a sticker inside. If the default password does not work, it may have been changed during the initial setup.
If the page takes too long to respond, the most common culprit is your device trying to use an active VPN or switching to mobile data because the router doesn't have an active internet connection yet. Turn off cellular data and VPNs. If it still fails, verify your default gateway using your device's network settings, as your router might be using a different IP. As a last resort, use a paperclip to press the physical RESET button on the router for 10 seconds to restore factory defaults.
For most Huawei and GL.iNet routers using this IP, the default username is 'admin' and the password is 'admin'. For portable hotspots, check the sticker located under the battery.
Smartphones often switch to mobile data if the Wi-Fi router doesn't have internet access yet. Turn off your phone's Cellular Data and disconnect any active VPNs, then try loading the page again.
Log in to the dashboard, go to Network Settings > Wi-Fi > WLAN Basic Settings. Enter your new password in the Wi-Fi Password field and save the changes.
No. IP addresses only contain numbers. Typing the letter 'l' instead of the number '1' will result in a search engine query instead of opening the router management page.
Keep the router powered on. Find the small RESET hole on the device, use a pin to press and hold the button inside for about 10 seconds until the lights blink. This restores the default password printed on the device label.